Step 1 - Install Ponyprog.
Step 2 - Configure Ponyprog interface setup according to your programmer (Menu bar Setup->Interface Setup).

Step 3 - Check whether programer is properly connected or not. Click on 'Probe' button this should give 'Test Ok' Notice window

Step 4 - Now Read the device Memory if the target device is connected to the serial port by programmer hardware by going into Menu bar > Command > Read All. If device read completed successfully it means that ponyprog can communicate with your microcontroller.

Step 5 - Now open the hex file by File > Open device file & write this data to the flash memory of microcontroller by issuing Command > Write all

Best viewed at Firefox 1024x768 resolution
|